remember, I use this page as a note pad, because, sometimes I lose paperwork š
antennas for 2m EME will either be
2x 10 element horizontal antennas-amplifiers Yagis
2Meter 10element World Best GT Antenna 2m10DXAP
or
2x 2×12 cross RHCP antennas-amplifiers Yagis
2m CROSS DX EME Antenna 2mCROSS24DXP
Coax for TX is 1-1/4 inch Rosenberger
Coax for RX is LCF-12-50
LNA will be from antennas-amplifiers as well
when all is proberly set up: PA can be Beko 1kw or LZ2US amplifier with enough backup to run low RPM
The homemade tower is a 2m tall tower section where the horizontal Emotator rotator is mounted on the botom
and the elevation rotator is mounted right above the thrust bearing. ((Rotator height: 23cm))
I use side bearings to take weight from the horizontal rotator.
The last part of the elevation boom will be finished with fibreglass tubes.